Call Us (480) 795-7199

ATR Performance R35 GTR Fuel feed and return set for Radium Hanger

$2,099.00

ATR Performance 1500HP fuel feed and return set.  Add Boost Logic fuel rails, Fuel pressure monitor kit, Radium hanger, and two brushless fuel pumps for a complete fueling solution.

Complete your 1500HP fuel system!

Radium Engineering Brushless Fuel Pump Hanger for R35 Nissan GTR

Directly From Radium:

The Radium Engineering fuel hanger completely replaces the factory in-tank fuel pump unit in the R35 GT-R and permits up to three 39mm diameter aftermarket pumps (brushed or brushless) to supply fuel to the engine. No permanent vehicle modifications are required for installation. The pumps are housed in an aluminum collector box that is kept full during operation. This ensures that fuel starvation does not occur, even during aggressive driving. The fuel pump outlet port is -10AN ORB female threaded and includes a 6AN male adapter, while the return port is -8AN ORB female threaded and includes a 6AN male adapter. The system is compatible with alternative fuels such as methanol, ethanol, E85, etc. Radium Engineering recommends reviewing the installation instructions (link above) before purchasing.

 

From ATR Performance:

ATR is located in the Phoenix area, and as such - We experience very warm temperatures (Often in excess of 110 degrees F).  We've run every different variety of fuel pump and hanger setups and found flaws in most.  The R35 fuel tank is located above the transmission and exhaust, and fuel is known to get quite warm in the summer months.  In addition to this, many brushed pumps such as the Walbro 450 and 525 heat the fuel even more.  In fact, ethanol can get hot enough to boil inside the R35 fuel tank.  This results in fuel cavitation, engine cutting out, and eventual fuel pump failure.  When we installed this Radium hanger with two Walbro branded BRUSHLESS fuel pumps and controllers, we were able to cut the fuel temps by a minimum of 15 degrees F and have never experienced a fuel pump failure in over 3 years of use with this setup.

Fitted with two Walbro BKS1001 brushless fuel pumps, this Radium hanger will support 1500HP while running on E85 ethanol.  Please NOTE that this hanger does NOT come with fuel pumps or fuel pump wiring - We sell these items separately.

GTR R35 Fuel Pressure Monitoring Kit

This harness and adapter block are made to be a plug n play option for 2009-2022 Nissan GTR with stock fuel rails.  The machined adapter block will bolt onto the back of the fuel rail.  Plug n play harness will plug into the driver side boost pressure sensor.  Please note that the vehicle will require a tuning revision to activate the sensor.  We offer Ecutek licensing, hardware, and tuning in house.  Please message us for details.

This kit uses high quality wiring and connector components, unlike the competition.  Look, fit, and finish are unrivaled.

This kit will accept any Motec or AEM fuel pressure sensor, or any other that uses an 1/8" NPT thread.  We do sell the AEM 150psi sensor separately, if needed.

GTR R35 AEM 150 PSI Fuel Pressure Sensor

This AEM 150psi fuel pressure sensor is to be used in conjunction with our R35 plug n play fuel pressure monitoring kit

Boost Logic fuel rail set without lines

TI Automotive brushless fuel pump and controller x2 (1500HP kit)

From TI Automotive:

TI Automotive's new in-tank brushless fuel pump utilizes advanced technology for maximum reliability and efficiency. The result is a next-generation pump for any type of engine offering precise control of fuel pressure, lower current draw, reduced heat and less noise.
Supporting up to 1000+ HP, the BKS1000 provides more power, more torque and more speed. Matched controller with simple power and ground operations for easy maintainability. The controller features sealed electronics for weather resistance.

Fuel: GAS or FLEX
Horsepower: 1000
Flow Rate (lph): 550
Pressure (psi): 40

 

Description

This kit was specifically designed to fit the Radium fuel pump hanger.  Our -10AN feed line and -6AN return lines will support 1500+ horsepower on ethanol.  We’ve added a 10 Micron serviceable fuel filter right before the fuel rails as well, to catch any small debris before it hits your fuel injectors.  These lines are made of a super light weight material and are compatible with all gasoline and alcohol based fuels.  This kit is fully fabricated and ready for install.  Parts included are:

 

  1. -10 Fuel feed line from top of fuel tank to fuel filter at batter compartment
  2. -10 Fuel feed line to 6 or 12 injector fuel rail setup
  3. -6 Fuel return line from flex fuel sensor to fuel tank  (We mount our flex sensors underneath the battery in battery compartment – Message us for more info
  4. 10 Micron Weldon 10GPM fuel filter
  5. Fuel filter bracket
  6. Radium fuel line retainer kit for underneath vehicle
  7. Weldon 10GPM adjustable fuel pressure regulator

This kit does not include the line from fuel rails to pressure regulator or flex sensor – There are too many different configurations on the market for this.   Message us with custom requests, in order to complete this kit.

 

Add Boost Logic fuel rails, Fuel pressure monitor kit, Radium hanger, and two brushless fuel pumps for a complete fueling solution.

Additional information

Weight 20 lbs
Dimensions 12 × 12 × 12 in

Reviews

There are no reviews yet.

Be the first to review “ATR Performance R35 GTR Fuel feed and return set for Radium Hanger”

Your email address will not be published. Required fields are marked *